Table of Contents
Advertisement
L The next step must be completed
within 90 seconds.
5
Handset:
Wait until "Enter Base PIN" is
displayed. i Enter the base unit
PIN (default: "0000"). i M
L If you forget your PIN, contact
your nearest Panasonic service
centre.
L When the handset has been
registered successfully, w stops
flashing.
Note:
L When you purchase an additional
handset, refer to the additional
handset's installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This allows the handset to end
its wireless connection with the system.
1
K (middle soft key)
2
{V}/{^}: "Base Unit Setup" i
M
3
{3}{3}{5}
4
{V}/{^}: "Deregistration" i
M
L The numbers of all handsets
registered to the base unit are
displayed.
5
Select the handset(s) you want to
cancel by pressing the desired
handset number. i M
L The selected handset number(s)
flashes.
L To cancel a selected handset
number, press the number again.
The number stops flashing.
6
{V}/{^}: "Yes" i M
L A confirmation tone sounds as
each handset number
disappears.
L The handset does not beep when
cancelling its own registration.
7
{ih}
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 3. Contact your
Panasonic dealer for details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at
a time.
Setting the repeater mode
1
K (middle soft key)
2
{V}/{^}: "Base Unit Setup" i
M
3
{V}/{^}: "Repeater Mode" i
M
4
{V}/{^}: Select the desired setting.
i M i {ih}
Note:
L After turning the repeater mode on or
off, w flashes on the handset
momentarily. This is normal and the
handset can be used once w stops
flashing.
Programming
27
Advertisement
Table of Contents
