Thermal Cut Off; Use; How To Use - Electrolux Z4680 SERIES Owner's Manual

HOW TO USE

The upright vacuum cleaner design allows use on multiple types of
carpeting and on upholstery or bare floors with attachments. When
using the attachment tools, place the handle in the upright
position. Do not place cleaner on furniture or steps as the brush
roll may cause damage.
1. Adjust cleaner height setting knob to lowest position for maximum
cleaning. Adjust to a higher setting to make pushing easier. For easy
adjustments, tilt the cleaner back to move the knob.
2. Plug electrical cord into outlet.
3. Step on handle release. Pull handle back to a comfortable
position.
4. Push On/Off power switch.
Store or
Use Attachments
Handle
3
Release

Use

Clean
Under

THERMAL CUT OFF

This cleaner has a special thermostat that protects the cleaner
in case of motor overheating. If the cleaner suddenly turns off,
follow this procedure:
1. Push on/off pedal once.
2. Unplug cleaner.
3. Check for source of overheating problem (i.e. full cyclonic dust
cup, clogged hose or clogged filter).
4. If a full cyclonic dust cup, clogged hose or clogged filter is found,
empty the cyclonic dust cup, unclog the hose or replace the
filters.
5. Wait at least 30 minutes before attempting to reuse the
cleaner.
6. After 30 minute cool down period, plug the cleaner in and push
the switch pedal. The cleaner should turn on.
7. If the cleaner still does not operate, take it to any Electrolux Call
Centre on 08706 055055 for repair authorisation.
4
ON/OFF
Handle
3
Release
7