Electrolux Z4680 SERIES Owner's Manual page 15

HEPA Cartridge Filters and Washable Hepa Filters.
Check the HEPA filters each time the dust cup is emptied. Replace twice a year or after every six times the dust cup is
emptied.
Pre-Motor Filter
Check the pre-motor filter each time the cyclonic dust cup is
emptied. Clean or replace as needed.
To Clean Pre-Motor Filter
1. Remove filter centered in the bottom of the dust cup
compartment.
2. Shake filter to remove excess dust. If necessary, the filter can
be cleaned by vacuuming with another cleaner or washing with
mild detergent.
3. Reinstall filter after completely dry.
NOTE: If rubber gasket separates from motor adapter,
reposition securely on top edge before using
cleaner.
Use GENUINE ELECTROLUX replacement pre-motor filters.
Latch
Filter Cartridge (One
complete unit)
Tabs
(Only for models with HEPA cartridge.)
To remove HEPA cartridge filters and
Washable HEPA filters
1. Push down latch and pull filter cassette back.
2. Then lift filter up and remove.
To replace HEPA cartridge filters and
Washable HEPA filters
1. Place bottom tabs of filter cassette into slots.
2. Rotate filter toward cleaner.
3. Push upward on the latch to secure into place.
NOTE: To have the benefit of a sealed HEPA system,
you must use one of the HEPA cartridge filter
systems.
NOTE: For rinsing instructions of the Washable HEPA
filter see the "Rinsing Directions for Rinsable
Filters on the previous page.
CAUTION: If your cartridge does not sayWashable HEPA
Filter" it is not reusable - do not wash.
Motor
Adapter
Gasket
Pre-Motor Filter
Motor
Adapter
1
3
15