Thermal Cut Off - Electrolux WorkZone Car and Stair Vacuum Z61A Owner's Manual

BEFORE YOU START
CHECK THE VOLTAGE
Before connecting the cleaner to an electrical supply, ensure that the voltage shown on the rating plate located beneath the
cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer.
CONNECTING TO YOUR ELEC TRIC I TY SUPPLY
Permanently connected to the clean er is a mains supply (2-core) cable fi tted with a non-rewirable plug incorporating a 13A fuse.
In the event of the fuse requiring replacement the fuse cover should be re moved using a small screw driv er. The old fuse MUST
be re placed by a 13A ASTA ap proved BS1362 fuse or a BSI approved fuse. The cover must be re placed before the plug is used
again. In the event of loss of the fuse cover, re place ments can be obtained from your Electrolux Retailers and must be of the
same colour as indicated by the col oured insert on the base of the plug.
In no circumstances must the plug be used without a correct fuse cover fi tted.
If the plug that is fi tted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fi tted.
Remove the fuse from the cut off plug.
The cut off plug should then be dis posed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket
in another part of your home.
The wires in the mains cable of this appliance are coloured in ac cord ance with the following code: Blue: Neu tral. Brown: Live.
As the colours of the wires in the mains cable of this appliance may not correspond with the col oured markings iden ti fy ing the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be con nect ed to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be con nect ed to the terminal which is marked with the letter L or coloured red.
If using a three-pin plug, do not make any con nec tion to the terminal marked with the letter E or by the earth symbol or col oured green or
green-and-yellow. This cleaner is dou ble in su lat ed and no earth con nec tion is nec es sary.
It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualifi ed elec tri cian, as
Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the
guarantee.
WARNING
The brush in the cleaning head rotates at high speed and can cause damage to the mains supply cable if the cleaner passes
over it during cleaning operations.
Care should be taken to ensure that this does not happen. If the cleaning head has accidentally passed over the mains supply cable the
following action should be taken:
1. Switch off and remove the plug from the socket outlet.
2. Examine the mains supply cable for damage (only after removing the plug from the socket outlet).
3. If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Service Agent
or a similar qualifi ed person.
4. NEVER use the machine with a damaged mains supply cable.
Proprietary carpet conditioning and air freshening ma te ri als
After using proprietary carpet conditioning powders, it is recommended that the fi lters be changed. Some of these preparations contain
sub stanc es which if left in the vacuum cleaner for extended periods could damage the plastic mouldings which form the structure of the
cleaner.
Many air fresheners, household deodorants, sprays and polishes contain a highly fl am ma ble gas propellant.
Because of this, it is particularly important that these products are used strictly in ac cord ance with the relevant manufacturerʼs
instructions.
It is essential that none of the above products are sprayed directly into the vacuum cleaner or any of its fi lters, hose assembly, dustbag
chamber or dust cup.

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner switches off, push
the switch to "Off" and unplug the cleaner. Check the cleaner for a possible source of overheating such as a full dust cup, a blocked hose or
clogged fi lter. If these conditions are found, fi x them and wait at least 60 minutes before attempting to use the cleaner. After the 60 minute
period, plug the cleaner back in and turn on the switch. If the cleaner still does not run, please call Electrolux on 08706 055055.
Fuse
Cover Cover
Fuse
13 Amp Fuse 13 Amp Fuse
Brown Brown
Blue
Cord Cord Cord
Clamp
3