Panasonic DMR-E85H Operating Instructions Manual page 8

1
STEP Connection
Connecting a satellite receiver, digital receiver or decoder
≥Decoder here means the device used to decode scrambled broadcasts (Pay TV).
≥Change the "AV2 Input" and "AV2 Connection" settings in the SETUP menu to match the connected equipment (➡page 39).
AV OUT
This unit's
rear panel
AV1 (TV)
AV2 (DECODER/EXT)
Connecting an amplifier or system component
∫ To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
"Digital Audio Output" (➡page 38).
≥You cannot use DTS Digital Surround decoders not suited to
DVD.
≥Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
AC IN
This unit's rear panel
RQT7460
8
8
Satellite receiver, digital
receiver or decoder's rear
panel
21-pin Scart cable
Y
RF IN
P
B
P
R
COMPONENT
RF OUT
VIDEO OUT
(NTSC:480P/480I,
PAL:576P/576I)
Amplifier's rear panel
OPTICAL IN
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
Viewing video from the decoder on the television while the
unit is stopped, or while recording
If you connected the television to the AV1 terminal and the decoder
to the AV2 terminal on this unit, press [0]i[ENTER]. ("DVD"
appears on the unit's display.)
Press again to cancel. ("TV" appears on the unit's display.)
≥If the television is compatible with RGB input, the RGB output
signal from the decoder can also be output from the main unit the
same way.
∫ Connection to a stereo amplifier
Audio cable
R - AUDIO -
R - AUDIO -
This unit's rear panel
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
Amplifier's rear panel
AUDIO IN
R L
Red White
Red White
R - AUDIO - L VIDEO S-VIDEO
OPTICAL
R - AUDIO - L VIDEO S-VIDEO
DIGITAL AUDIO OUT
(PCM/BITSTREAM)