A) Identification Of Main Parts; B) How To Assemble Your Cleaner; C) How To Operate Your Cleaner - Panasonic MC-CG881K Operating Instructions Manual

A - IDENTIFICATION OF MAIN PARTS
A) Floor nozzle
B) Connection pipe
C) Hose
D) Suction regulator
E) Curved wand
F) Telescopic wand
G) Dusting brush
H) Crevice nozzle
I ) Upholstery nozzle
J) Hose inlet
K) Dust indicator
L) Dust cover
M) ON/OFF Switch pedal
N) Cord rewind pedal
O) Variable power control
P) Exhaust cover
Q) Plug
R) Paper dust bag (in body)
S) Basket
B - HOW TO ASSEMBLE YOUR CLEANER
B-1 Insert the connection pipe into the hose inlet until it
locks.
When removing the hose, push the two connection
buttons down while pulling out the connection pipe.
NOTE: Do not bend, pull and step on the hose or put
anything heavy on it.
B-2 Insert the curved wand into the upper end of the
telescopic wand.
Twist the telescopic wand so that the round hole will fit
into the tab on the curved wand.(When removing the
curved wand, push the tab down while pulling out the
telescopic wand.)
Attach the floor nozzle to the other end. (Removal as
per reverse procedure)
B-3 Hold the grip and the extension adjuster and extend
the telescopic wand to the required length.
C - HOW TO OPERATE YOUR CLEANER
C-1 Pull out the mains lead and put the plug into the
socket outlet.
C-2 Gently press the center of the switch pedal to turn ON
the appliance. Press the pedal again to turn it OFF.
C-3 Power control
The suction power can be adjusted depending on the
type of flooring.
The symbols on the controls indicate the type of use
the settings are suitable for.
:Curtains, Lightweight fabrics
:Upholstery, Cushions
:Parquet flooling
:Shallow-pile carpet
:Deep-pile carpet
Turn the rotary selector to the desired suction power
setting.
C-4 Switching between carpet and flooring
Flooring: Press lever A
Carpet: Press lever B
C-5 The curved wand of the hose is attached with a
manual suction regulator, which allows you to
reduce the suction level easily.
C-6 The dusting brush can be set between the telescopic
wand and the floor nozzle if you want. Remove the
floor nozzle by pressing the release pedal and you
can use the dusting brush easily anytime.
C-7 After you finish vacuuming, remove the plug from the
socket outlet and press the cord rewind pedal.
When rewinding the mains lead, press the cord
rewind pedal by holding the plug so that it does not
become damaged.
C-8 Storage position
Slide the wand holder straight into the wand supporter
on the under side of the main body.
C-9 Park position
For short breaks during vacuuming, slide the wand
holder straight into the wand supporter on the rear
side of the main body.
NOTE: When you use park position, we suggest that
you switch the appliance off.
4