Setting The Remote Code - Panasonic KX-TG2680N Operating Instructions Manual

Setting the Remote Code

The remote code prevents unauthorized people from accessing your unit
and listening to your messages. Choose any 2-digit number (00–99).
The factory preset remote code is "11". If you do not program your own
remote code, you can use "11".
Use the handset near the base unit. Make sure the unit is in the
standby mode initially.
Press
1
(FUNCTION/CH)
Press or
2
Ö
points to "Program".
3 Press (Yes key).
á
4 Press or
Ö
points to "TAD program".
Press (Yes key).
5
á
•The base unit display shows programming
options.
6 Press .
(1)
•The current remote code is displayed on the
base unit.
7 Enter a remote code using a 2-digit
number (00–99).
Press (Save key).
8
á
•A beep sounds.
•To return to the standby mode, press (OFF).
•If 6 beeps sound during programming, a wrong key was pressed. Enter the
correct number.
To check the remote code
Repeat steps 1 to 6.
•The current remote code is displayed on the base unit. When finished, press
(OFF).
.
repeatedly until the arrow
Ñ
repeatedly until the arrow
Ñ
H
Program
Calling pager
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes
Set dial mode
H
TAD program
GF H
=Yes
Answering
system setting.
See base unit.
Base unit display
Remote code
:11
69