Yamaha HTR-6295 Owner's Manual page 67

Problem
No picture. An appropriate video input is not selected
on the video monitor.
An appropriate HDMI OUT jack is not
selected.
The external video component is
connected to one of the HDMI 1-4 jacks
or HDMI IN (VIDEO AUX) jack while
your video monitor is connected to the
MONITOR OUT (COMPONENT
VIDEO or VIDEO) jacks.
This unit outputs the video signals not
supported by the video monitor connected
to one of the HDMI OUT jacks.
Video signals are input from a game
console while your video monitor is
connected to one of the HDMI OUT jacks.
Non-standard video signals are input.
The picture is The video software is copy-protected.
disturbed.
No sound. Incorrect input or output cable
connections.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down or muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.
"Audio Output" in "HDMI" is set to
"TV".
A proper audio decoder is not selected.
Only the center When a monaural source sound field
speaker outputs
program is applied, sound of all channels
substantial sound. are output from the center speaker for
some surround decoders.
The playback component or speakers are
not connected properly.
Cause
Select an appropriate video input on the video
monitor.
Select the HDMI OUT jack which your video
monitor is connected.
Connect the external video component to the video
input jacks other than the HDMI 1-4 jacks or connect
the video monitor to one of the HDMI OUT jacks or
HDMI IN (VIDEO AUX) jack.
Displays the advanced setup menu and select
"VIDEO" in "INIT" to reset the video parameters.
Displays the advanced setup menu and set
"MON.CHK" to "YES".
Connect the video monitor to the MONITOR OUT
(COMPONENT VIDEO) jacks.
Connect the video monitor to the MONITOR OUT
(COMPONENT VIDEO or VIDEO) jacks.
Connect the cables properly. If the problem persists,
the cables may be defective.
Rotate the TINPUT selector (or press dInput
selection key) to select the desired input source.
Secure the connections.
Turn up the volume.
Display "Signal Info" in the Option menu and check
the input signal format.
If "No Signal" is displayed, check if the playback
component is properly connected to this unit (or a
proper input source is selected).
If "___" is displayed, the input signal in that format
cannot be reproduced by this unit.
Connect HDMI components that support the HDCP
copy protection standards.
Set "Audio Output" (Function Setup → HDMI →
Audio Output) to the other setting.
Display the Option menu and set "Decoder Mode" to
"Auto".
Try another sound field program.
Connect the cables properly. If the problem persists,
the cables may be defective.
Troubleshooting
Remedy
See
page
—
40
14, 16
60
60
14
14
16
24
11
24
—
76
49
41
27
12, 16
63
En