Table of Contents
Advertisement
Step
2.
Enter VSI view.
3.
Specify static signaling for
PWs, and enter VSI static
view.
4.
(Optional.) Specify whether
to switch traffic from the
backup PW to the primary
PW when the primary PW
recovers, and set the wait
time for the switchover.
5.
Configure a static PW and
enter VSI static PW view.
6.
Configure a backup static PW
and enter VSI static backup
PW view.
7.
Return to user view.
8.
Manually switch traffic of the
specified PW to its backup
PW.
Configuring LDP PW redundancy
Step
1.
Enter system view.
2.
Enter VSI view.
3.
Specify LDP signaling for
PWs, and enter VSI LDP
signaling view.
4.
(Optional.) Specify whether
to switch traffic from the
backup PW to the primary
PW when the primary PW
recovers, and set the wait
time for the switchover.
5.
Configure an LDP PW and
enter VSI LDP PW view.
Command
vsi vsi-name [ hub-spoke ]
pwsignaling static
revertive { wtr wtr-time | never }
peer ip-address [ pw-id pw-id ]
[ in-label label-value out-label
label-value ] [ hub |
no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
backup-peer ip-address [ pw-id
pw-id ] in-label label-value
out-label label-value [ pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
return
l2vpn switchover peer
ip-address pw-id pw-id
Command
system-view
vsi vsi-name [ hub-spoke ]
pwsignaling ldp
revertive { wtr wtr-time | never }
peer ip-address [ pw-id pw-id ]
[ hub | no-split-horizon |
pw-class class-name |
tunnel-policy tunnel-policy-name ]
467
Remarks
N/A
By default, no PW signaling
protocol is specified for the VSI.
By default, when the primary PW
recovers, traffic is immediately
switched back from the backup
PW to the primary PW.
By default, no static PW is
configured.
By default, no backup static PW is
configured.
If both a default PW ID in the
default-pw-id command and a
PW ID in the backup-peer
command are configured, the PW
ID in the backup-peer command
is used. If only a default PW ID is
configured, the default PW ID is
used. If no default PW ID is
configured, you must provide a
PW ID in the backup-peer
command.
N/A
N/A
Remarks
N/A
N/A
By default, no PW signaling
protocol is specified for the VSI.
By default, when the primary PW
recovers, traffic is immediately
switched back from the backup
PW to the primary PW.
By default, no LDP PW is
configured.
Advertisement
Table of Contents
