Pilot Screw - Honda V 45 SABRE-VF750S 1982 Shop Manual

FUEL SYSTEM
PILOT SCREW
REMOVAL
NOTE:
nlll
pilot
screws are factory pre-set
and
should not
be
removed unless the carbure-
tors are overhauled.
The pilot screw plugs are factory installed
to prevent pilot screw misadjustment. Do
not remoye the plugs unless the pilot
screws are being removed.
Cover all opening with tape to keep metal
particles out when the plugs are drilled.
Center punch the pilot screw plug to center the
drill point.
Drill through the plug with 8 4 mm (5/32 in) drill
bit, being careful not to drill into the pilot screw.
CAUTION;
Be careful not to drill into the pilot screw.
All pilot
SerE-Wi
must be replaced avenI/only
one requireJ
it
for proper pilot screw adjust-
ment (page 4-18).
Force a setf.tapping 4 mm screw (HIe 069399,
PIN 93903-35410)
into
the drilled plug and
continue turning the screwdriver until the plug
rotates with the screw.
Pull on the screw head with pliers to remove the
plug.
Use compressed air to cleln the pilot screw area and
remove metal shavings.
4-10
•
"
c;j) HONDA
V45
:.~::!
Date of
Issue: May. 1982
© HONDA MOTOR CO., LTD.
-
-