Valve Clearance - Honda V 45 SABRE-VF750S 1982 Shop Manual

MAINTENANCE
IGNITIDN SYSTEM
NOTE:
The ignition system is transistorized and Cln-
not be adjusted. If tht ignition timing is in-
correct, check the spark unit and pulse gent·
rator and replace any faulty parts (Section
20) .
Remove the alternator .nd left crankcase collers.
Wipe off the oil from
the
flywheel.
Connect the timmg light to the high tension wife
of the No.1 cylinder.
Start the engine and I.t
it
idle.
IDLE SPEED: 1,000 t 100
rpm
The timing is correct if the UFO, mark on the fly-
wheel .ligns with the crankcase rear mating
surfaces.
VALVE CLEARANCE
NOTE
Inspect and adjust \/,1118 clearance while the
engine is cold. (Below 3S"C,9S"FI
Drain coolant from engine
,nd
frame (page 6-3).
NOTE
Drain the coolant into a clean container for
reuse. Scheduled coolant replacement is ellery
2 years or 24,000 miles (38,600 kmJ.
Remove the right and left frame side ccovers aod
remove the seat.
Turn the fuel valve "OFF" (V45 MAGNA) and
remove the fuel tank (V45 SABRE).
Lift up the fuel tank by removing the front mount·
ing bOlts (V45 MAGNA) . Be sore the tank is less
than half full.
If not. drain the tank.
Remove the spark plug caps.
3-10
J6
-
- ------
W HONDA
~ V45 ~!:=!
MATING SURFACES
SIDE COVER
Date of Issue: October, 1982
©
HONDA MOTOR CO .. LTD .
-
-