Page 1
CD RECEIVER CD-RECEIVER RECEPTEUR CD CD-RECEIVER KD-SX992R/KD-SX921R KD-SX992R SOUND KD-SX992R SOURCE KD-SX921R KS-SX921R For installation and connections, refer to the separate manual. Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch. Pour l’installation et les raccordements, se référer au manuel séparé.
Position And Reproduction Of Labels Bottom panel of the main unit CAUTION: Invisible laser ADVARSEL: Usynlig laser - VARNING: Osynlig laser- VARO: Avattaessa ja suo- radiation when open and stråling ved åbning, når strålning när denna del jalukitus ohitettaessa olet interlock failed or defeated.
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. CONTENTS SOUND ADJUSTMENTS ....22 How to reset your unit .......
LOCATION OF THE BUTTONS Control panel Display window i o ; ; TP PTY (traffic programme/programme type) /¢ buttons 2 5 (up) button button 3 ∞ (down) button a AUX (auxiliary) input 4 Remote sensor 5 Display window Display window 6 0 (eject) button s Main display 7 FM AM button...
Preparing the remote controller Place the battery. Slide the battery into the holder with the + side facing upwards so that the battery is fixed in This section is only for KD-SX992R. the holder. Lithium coin battery (product number: KD-SX921R can also be remotely controlled with CR2025) an optionally purchased remote controller.
Remote controller the radio (or the DAB tuner). Each time you press the button, the preset This section is only for KD-SX992R. station (or service) number increases, and the selected station (or service) is tuned in. KD-SX921R can also remotely controlled with an •...
BASIC OPERATIONS Turning on the power Adjust the volume. To increase the volume. Turn on the power. “HELLO” appears on the display. To decrease the volume. Volume or audio level Note on One-Touch Operation: indicator (see page 27) When you select a source in step 2 below, the Volume level appears power automatically comes on.
RADIO OPERATIONS Listening to the radio Start searching a station. Press ¢ to search You can use either automatic searching or manual stations of higher searching to tune in to a particular station. frequencies. Searching a station automatically: Auto search Press 4 to search stations of lower...
Page 9
Searching a station manually: • If you release your finger from the button, the manual mode will automatically turn off Manual search after 5 seconds. • If you hold down the button, the frequency Select the band (FM1 – 3, AM). keeps changing (in 50 kHz intervals for FM and 9 kHz intervals for AM –...
Manual preset Storing stations in memory You can preset up to 6 stations in each band (FM1, You can use one of the following two methods to FM2, FM3 and AM) manually. store broadcasting stations in memory. Ex.: Storing an FM station of 88.3 MHz into the •...
Tuning in to a preset station Press and hold the number button (in this example, 1) for more than 2 You can easily tune in to a preset station. seconds. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory”...
RDS OPERATIONS What you can do with RDS To use Network-Tracking Reception You can select the different modes of network- tracking reception to continue listening to the RDS (Radio Data System) allows FM stations to same programme in its finest reception. send an additional signal along with their regular When shipped from the factory, “AF”...
Using TA Standby Reception Press and hold SEL (select) for more than 2 seconds so that one of the TA Standby Reception allows the unit to switch PSM items appears on the display. temporarily to Traffic Announcement (TA) from the (PSM: see page 26.) current source (another FM station, CD or other connected components).
Page 14
Using PTY Standby Reception Finish the setting. PTY Standby Reception allows the unit to switch temporarily to your favourite programme (PTY: Programme Type) from the current source (another FM station, CD or other connected components). • PTY Standby Reception will not work if you are listening to an AM station.
Page 15
Searching your favourite programme Select one of the twenty-nine PTY codes. (See page 18.) You can search any one of the PTY codes. In addition, you can store your 6 favourite Selected code name programme types in the number buttons. appears on the display.
Other convenient RDS functions To search your favourite programme type and adjustments Press and hold TP PTY for more than 2 seconds while listening to an FM Automatic selection of the station station. when using the number buttons Usually when you press the number button, the preset station is tuned in.
Changing the display mode while Setting the TA volume level listening to an FM station You can preset the volume level for TA Standby Reception. When a traffic programme is received, You can change the initial indication on the display the volume level automatically changes to the preset to station name (PS NAME), station frequency level.
Page 18
PTY codes NEWS: News CHILDREN: Entertainment programmes for AFFAIRS: Topical programmes expanding children on current news or affairs SOCIAL: Programmes on social activities INFO: Programmes which impart advice RELIGION: Programmes dealing with any on a wide variety of topics aspect of belief or faith, or the SPORT: Sport events nature of existence or ethics...
CD OPERATIONS Playing a CD The CD–in indicator lights up. Open the control panel. Total playing time of Total track number the inserted disc of the inserted disc Note: When an external component is connected to the AUX jack in the control panel, be careful of handling a CD. Elapsed Insert a disc into the loading slot.
To stop play and eject the disc To go to a particular track directly Press 0. CD play stops, the control panel opens, then the disc automatically ejects from the loading slot. If you change the source, the CD play also stops (without ejecting the disc this time).
To play back tracks repeatedly (Repeat Play) Playing a CD Text You can play back the current track repeatedly. In a CD Text, some information about the disc Press MODE to enter the functions (its disc title, performer and track title) is recorded. mode while playing a disc.
(bass) (treble) (fader) (balance) WOOFER LOUD (volume) (only for KD-SX992R) (loudness) Note: Indication To do: Range Normally, the control dial works as the volume Adjust the bass. –06 (min.) control. So you do not have to select “VOL” to adjust the volume level.
Indication For: Preset values Selecting preset sound modes LOUD (C-EQ: custom equalizer) USER (Flat sound) ROCK Rock or You can select a preset sound mode disco music (C-EQ: custom equalizer) suitable to the music CLASSIC Classical –02 genre. music • There is a time limit in doing the following POPS Light music procedure.
• When “CEQ LINK” is set to “LINK ON” Select the item you want to adjust. The selected sound mode can be stored in • See page 22 for details. memory for the current source. Each time you change to the same source, the same sound mode is also recalled and shown on the display.
OTHER MAIN FUNCTIONS Setting the clock To check the current clock time while the unit is turned off, press DISP (display). The power turns on, the clock time is shown for 5 Press and hold SEL (select) for more seconds, then the power turns off. than 2 seconds so that one of the PSM items appears on the display.
Page 26
Press SEL (select) to finish the setting. Not selectable when the DAB tuner is connected. Displayed only when the DAB tuner is connected. *** Only for KD-SX992R. **** Displayed only when one of the following sources is selected – FM, AM and CD.
Page 27
To select the dimmer mode – DIMMER when the unit is turned on. (only for KD-SX992R) When shipped from the factory, the clock is set to be shown on the display. When you turn on the car head lights, the display automatically dims (Auto Dimmer).
Page 28
To select the telephone muting – To select the external component to use – EXT IN This mode is used when a cellular phone system is connected. Depending on the phone system used, You can connect the external component to the CD select either “MUTING 1”...
Detaching the control panel Attaching the control panel Insert the right side of the control panel You can detach the control panel when leaving into the groove on the panel holder. the car. When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder.
Track number with your unit. If you have another CD automatic changer, consult your JVC IN-CAR ENTERTAINMENT dealer for connections. • For example, if your CD automatic changer is one of the KD-MK series, you need a cord (KS-U15K) for Disc number** connecting it to this unit.
RPT indicator lights up on To show the CD Text information the display. This is possible only when connecting a JVC CD Then, each time you press RPT automatic changer equipped with CD Text reading (repeat), the repeat play mode capability.
EXTERNAL COMPONENT OPERATIONS Portable MD player, etc. AUX input Playing an external component • If “LINE IN” does not appear on the display, see page 28 and select the external input (“LINE IN”). • Displayed only when one of the following You can connect two external components to this sources is selected –...
We recommend that you use DAB (Digital Audio Broadcasting) tuner KT-DB1500 with your unit. one of the services If you have another DAB tuner, consult your JVC IN-CAR ENTERTAINMENT dealer. • Refer also to the Instructions supplied with your A typical ensemble has 6 or more programmes DAB tuner.
Page 34
To change the display information while Start searching an ensemble. tuning into an ensemble Press ¢ to search Normally service name is shown on the display. ensembles of higher If you want to change the display information, frequencies. press DISP (display). Each time you press the button, the Press 4 to search...
Storing DAB services in Press and hold the number button memory (in this example, 1) you want to store the selected service into for more than 2 seconds. You can preset up to 6 DAB services in each DAB band (DAB1, DAB2 and DAB3) manually. Select the DAB tuner.
Tuning in to a preset DAB Note: When reception switches between DAB and FM, the service listening volume level may increase or decrease inconveniently. This change in the volume level results from unequal audio injection levels at broadcaster site, You can easily tune in to a preset DAB service. but not from the malfunction of this unit.
TROUBLESHOOTING What appears to be trouble is not always serious. Check the following points before calling a service center. Symptoms Causes Remedies • Sound cannot be heard from The volume is turned to the Adjust it to the optimum level. the speakers.
MAINTENANCE Handling CDs Moisture condensation Moisture may condense on the lens inside the unit in the following cases: This unit has been designed to reproduce CDs, • After starting the heater in the car. CD-Rs and CD-RWs. • If it becomes very humid inside the car. Should this occur, the unit may malfunction.
Installation Size: 182 mm × 52 mm × 150 mm Line-Out Level/Impedance: Panel Size: 188 mm × 58 mm × 14 mm KD-SX992R: 4.0 V/20 kΩ load Mass: 1.4 kg (excluding accessories) KD-SX921R: 2.0 V/20 kΩ load Output Impedance: 1 kΩ...
Page 40
Having TROUBLE with operation? Please reset your unit Refer to page of How to reset your unit Haben Sie PROBLEME mit dem Betrieb? Bitte setzen Sie Ihr Gerät zurück Siehe Seite Zurücksetzen des Geräts Vous avez des PROBLÈMES de fonctionnement? Réinitialisez votre appareil Référez-vous à...
JVC kits d’installation, consulter votre revendeur IN-CAR ENTERTAINMENT dealer or a company Einbausatzes brauchen, wenden Sie sich an ihren JVC over inbouwpakketten contact op met uw JVC car audio Autoradiohändler oder ein Unternehmen das diese d’autoradios compagnie dealer of een dealer of een bedrijf dat inbouwpakketten levert.
Page 42
Kupfergeflechtdraht oder Stahldraht verwenden. gros et les plus courts possibles telle qu’une barre verdwijnt, moet u contact opnemen met uw JVC car audio • Maximum input of the speakers should be no more Bleibt Störgeräusch bestehen, wenden Sie sich an de cuivre ou une tresse.
Page 43
SX992R) Geräts vor dem Einbau, muß diese Leitung Orange with white stripe Naar de antenne (indien aanwezig) Zum Autolichtschalter (nur für KD-SX992R) angeschlossen werden, da sonst die Orange mit weißem Streifen À l’interrupteur d’éclairage de la voiture Stromversorgung nicht eingeschaltet werden kann.
Page 44
Abbidung oben.) – Seulement pour le KD-SX992R. Le niveau de sortie – Only for KD-SX992R. The line output level of this – Alleen voor KD-SX992R. Het uitgangsniveau van het – Nur für KD-SX992R. Der Ausgangspegel dieses Geräts de ligne de cet appareil est maintenu à...