Input Select - Panasonic BT-LH2600W Operating Instructions Manual

Main Menu
(continued)

INPUT SELECT

Sub menu Settings
VIDEO / Y/C
<AUTO>
<NTSC>
<PAL>
NTSC SETUP
<75>
<00>
YP P /RGB
<YP
B R
<RGB-VIDEO>
<RGB-COMP.>
COMPONENT
<SMPTE>
LEVEL
<B75>
<B00>
RGB SYNC
<G-ON>
<EXT>
COMP.
*1 "AUTO" is set when the monitor is shipped from the factory, but if there are concerns about noise etc. from outside the
input signal, we recommend assigning specific format.
g COMP.
The following menus are switched by selecting "RGB-COMP." in "YP
Sub menu Settings
*1
AUTOSETUP
H POSITION
<0–60>
(Factory preset setting: 30)
V POSITION
<0–60>
(Factory preset setting: 30)
PHASE
<0–31>
(Factory preset settings:
CLOCK
<700–1800>
(Factory preset settings:
WXGA/XGA
<XGA>
<WXGA>
*1 "EXECUTING" is displayed while "AUTOSETUP" is being executed, and "COMPLETE" is displayed when
"AUTOSETUP" is completed.
If "AUTOSETUP" cannot be completed, "INCOMPLETE" is displayed.
*2 Each "RGB-COMP." input compatible format can be adjusted.
Explanation
P >
B R
Explanation
page 28)
page 28)
The underlined values are factory preset setting values.
Used to select the input format for VIDEO and Y/C input.
<AUTO> Either NTSC or PAL is automatically selected.
<NTSC> NTSC
Selects the NTSC setup level.
<75> Select this when using with a setup signal of
7.5 IRE. (The inner parts of the monitor are set
to the 7.5 IRE setup level to suit the black level)
<00> Select this when there is no setup level signal.
Selects either YP P (Component) or RGB input mode.
B R
<YP P > Selects the YP
B R
<RGB-VIDEO>Selects the video RGB signal.
<RGB-COMP.> Selects the PC RGB signal.
Selects YP P (Component) signal input level.
B R
<SMPTE> When the signal level specified in SMPTE is
Chroma 100 IRE P
<B75> Select this when connecting a betacam or
simliar devices set to 7.5 IRE. (The inner parts
of the monitor are set at 7.5 IRE setup level to
suit the black level)
<B00> Select this when connecting a betacam or similar
devices that are not setup to the IRE level.
Selects the SYNC when using RGB-VIDEO input.
<G-ON> Select when a synchronizing signal is
superimposed on the G signal.
<EXT> Select when an external synchronizing signal is
received in synchronization.
Performs analog PC settings. (Refer to "COMP." below)
P /RGB" in the "INPUT SELECT" menu.
B R
The underlined values are factory preset setting values.
Screen automatic adjustment is performed when "RGB-
COMP." is selected in "YP
menu. "AUTOSETUP" is performed if a different screen is
displayed, and "YES" is selected.
Used to adjust the picture display position in the horizontal
*2
direction.
Used to adjust the picture display position in the vertical
*2
direction.
Used to adjust the clock phase with 1/32 clock phases.
Used to adjust the sampling clock in dot units.
Switches between WXGA and XGA.
<PAL> PAL
P signal.
B R
, P = 0.7 Vp-p.
B R
P /RGB" in the "INPUT SELECT"
B R
*2
*1
*2
27