Instruction
To set the clock
1. Press "CLOCK button".
is displayed.
blinks.
2. Press "TIMER setting button"
to set the clock to the present
time.
Holding down "
increases or decreases the time display.
3. Press "CLOCK button".
blinks.
Turn the breaker ON
• Turning ON the breaker opens the flap,
then closes it again. (This is a normal pro-
cedure.)
NOTE
Tips for saving energy
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps save energy.
• Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them
once in about every two weeks.
Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Mode
COOL
HEAT
DRY
• Operation outside this humidity or temperature range may cause a safety device to disable the system.
58
" or "
" button rapidly
Operating conditions
Outdoor temperature: < 3/4MK(X)S>–10 to 46 ˚C
<RK(X)S>–10 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
Outdoor temperature: < 3/4M
XS>
–15 to 21 ˚C
<
RXS>
–15 to 21 ˚C
Indoor temperature: 10 to 30 ˚C
Outdoor temperature: < 3/4MK(X)
S>
–10 to 46 ˚C
<RK(X)S>–10 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE
FAN
SWING
SILENT
ON
CANCEL
OFF
TIMER
Recommended temperature setting
For cooling:26°C – 28
For heating:20°C – 24°C
If operation is continued out of this range
• A safety device may work to stop the operation.
(In multi system, it may work to stop the operation of the out-
door unit only.)
• Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
SiBE06-514A
2
1.3
°C
9
System Configuration