Ethertalk; Preparations; Configuration Procedure - Xerox 4112 System Administration Manual

Configuration
Notes
•
•
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
2. Enable the IPP port.
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
5. After the machine is restarted, print out the Printer Settings List to confirm that the IPP
Note
Configure the IPP as necessary. Refer to IPP on page 3-14 for the IPP configuration.
Configuration on the computer
See Chapter 2 Configuration on the computer on page 2-2.

EtherTalk

Preparations

The following item is required when using an EtherTalk network:
•

Configuration procedure

Overview
The machine can be connected to computers using an EtherTalk network.
The following is the procedure to connect the machine to EtherTalk network:
•
•
2-6
Downloaded From ManualsPrinter.com Manuals
The configuration can also be performed using IP configuration tools included in
CentreWare Internet Services or CentreWare Utilities. Refer to "Using CentreWare Internet
Services"
Enable the SOAP port and the SNMP port in most cases.
on page 1-10.)
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select IPP and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
page 1-11).
port is enabled.
A network environment where EtherTalk can be used.
Configuration on the Machine: Set up EtherTalk on the machine.
Configuration on the Computer: Install the print driver.
System Administration Guide
Xerox 4112/4127 Copier/Printer