Car Navigation System - Panasonic CQ-VD6503N Operating Instructions Manual

Car Navigation System

Preparation:
¡Connect the Car Navigation System.
¡Specify the correct terminal that is connected to the car navigation system in the
Car Navigation Mode Selection
Press [NAVI] to change to the car naviga-
tion mode.
Press [NAVI] again to cancel.
To switch Operation Screen ON, press [ENTER] on the
remote control.
Note:
¡If the navigation mode is ON, only the audio signal is
switched while the video signal remains as it is.
¡The volume of the voice guidance from the car naviga-
tion system can be set. (a
¡Press [NAVI] after making sure that the power button
on the main unit is set to on. Pressing [NAVI] allows
the navigation mode to be activated even if the power
button of the main unit is set to off, but operations may
be different from those in other modes in this case.
¡The position adjustment of navigation screen shall be
performed at the navigation unit side.
Connecting with Panasonic Car Navigation System
(e.g. CN-DV2300N, option)
Connect a Panasonic car navigation system to RGB
connector.
page 20)
NAVI INPUT
PWR
SRC
TA
VOL
MUTE
P-MODE
ASPECT
ASP
TILT
. (a page 20)
ALBUM
FOLDER
TUNE
TRACK
NAVI NAVI
CQ-VD6503N
[NAVI]
CQ-VD6503N
14
15