Panasonic CQ-VD6503N Operating Instructions Manual page 38

Settings
(AUDIO continued)
SP SETUP
(Speaker set up)
37
Setting the absence/presence and size of each speaker
FRONT
SMALL : for small speakers, or when bass playback
is not possible
: for large speakers, when bass playback is
LARGE
possible (at least 100 Hz or lower)
CENTER
NONE : when not using a centre speaker
SMALL : for small speakers, or when bass playback
is not possible
LARGE : for large speakers, when bass playback is
possible (at least 100 Hz or lower)
* A centre speaker (option, EAB-CF2 recommended) is
required.
SUR
NONE : when not using a surround speaker
SMALL : for small speakers, or when bass playback
is not possible
LARGE : for large speakers, when bass playback is
possible (at least 100 Hz or lower)
SUB - W
NO : when not using a subwoofer
YES : when using a subwoofer
* A subwoofer (option, CJ-SW3003 recommended) is
required. A power amplifier (option) is also required for
connecting a subwoofer.
Note:
¡While the private mode is active, only
adjusted.
38
CQ-VD6503N
(continued)
(Front speaker setting)
default:
LARGE
(Centre speaker setting)
default:
NONE
(Surround speaker setting)
default:
LARGE
(Subwoofer speaker setting)
default:
can be
FRONT
PHASE
: subwoofer phase 0 degree
0°
180° : subwoofer phase 180-degree inverted
Note:
¡ This setting is feasible only when
.
YES
SP LEVEL
Adjusting the output balance of each speaker
FRONT L
] [
: down,
CENTER
] [
: down,
FRONT R
] [
: down,
R SUR
¡
] [
: down,
L SUR
¡
] [
: down,
SUB - W
] [
: down,
Setting range: – 10 dB to + 10 dB (1 dB steps)
NO
¡If the speaker setting is
test signal is not output and that speaker cannot be
selected.
¡ Turn rotary volume controller or press [+] or [–]
(VOL) to adjust the volume of the test signal.
(Phase setting)
is set to
SUB-W
default:
(Speaker level)
(Left front speaker output bal-
ance)
: up
(Centre speaker output bal-
ance)
: up
(Right front speaker output
balance)
: up
(Right surround speaker out-
put balance)
: up
(Left surround speaker output
balance)
: up
(Subwoofer speaker output
balance)
: up
default: ± 0 dB for all speakers
or for a speaker, the
NONE NO
0°