Table of Contents
Advertisement
3. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an Incline Axle Screw (30). Tighten the Incline
Axle Screw into one end of the Incline Axle (29). Next,
apply a small amount of the included grease to the
Incline Axle.
Align the indicated tubes on the Incline Frame (5) with
the tubes on the Base (1). Make sure that the Incline
Frame is turned so the V-shaped grooves are on
top. Insert the Incline Axle (29) through the Incline
Frame and the Base. Note: It may be helpful to tap the
Incline Axle with a rubber mallet to insert it.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto the other Incline Axle Screw (30). Tighten the
Incline Axle Screw into the open end of the Incline Axle
(29).
4. Attach the Incline Bracket (24) to the lower end of the
Upright (2) with the M10 x 85mm Bolt (25) and an M10
Nylon Locknut (26). Do not overtighten the Nylon
Locknut; the Incline Bracket must pivot easily.
5. The Console (87) requires two "AA" batteries (not
included). Alkaline batteries are recommended. To
install batteries, turn the Console face down and
remove the Battery Cover (97), as shown in the inset
drawing. Next, insert two batteries into the Console.
Make sure that the negative ends of the batteries
(marked "—") are touching the springs in the
Console. Then, reattach the Battery Cover.
Carefully feed the Resistance Cable (57) down through
the Upright (2) until the end of the Resistance Cable
extends from the bottom of the Upright. Next, connect
the console wire to the Extension Wire (51).
Attach the Console (87) to the Upright (2) with the four
Console Screws (35) and the four Console Washers
(98) packaged with the Console. Be careful to avoid
pinching the wires.
3
V-shaped Groove
5
33
29
Grease
Tubes
33
58
1
30
Tubes
4
2
24
26
25
5
87
97
Console
Wire
57
51
98
2
97
35
35
6
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical crosstrainer
regularly. Replace any worn parts immediately.
58
For smooth
operation of
the elliptical
crosstrainer,
30
the incline
frame should
be kept clean.
Using a soft
cloth and mild
detergent,
clean dust and
other residue
from the incline
frame where the wheels make contact with it. Other
parts of the elliptical crosstrainer can also be cleaned
in this manner. Never use abrasives or solvents.
87
LUBRICATING THE INCLINE BRACKET
The incline
bracket and the
bolt on which it
pivots should be
Bolt
regularly lubri-
cated. Apply a
Incline
small amount of
Frame
the included
lubricant to the
Wheel
bolt and
between the
bracket and the
upright.
11
Upright
Incline
Bracket
Advertisement
Table of Contents
