Table of Contents
Advertisement
Chapter 2
Installing Device
2
Figure 2: Panel Mounting
1. Screw
2. Panel Adaptor
2.
Install the supplied screws to secure the adapters to the panel.
Section 2.2
Connecting Power
The M2200 supports single or dual redundant AC and/or DC power supplies. The use of two power modules is
recommended to provide redundancy and load balancing.
The M2200 can be equipped with either a screw-type or pluggable terminal block, which provides power to both
power supplies. The screw-type terminal block is installed using Philips screws and compression plates, allowing
either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for secure, reliable connections
under severe shock or vibration.
NOTE
• For maximum redundancy in a dual power supply configuration, use two independent power
sources.
• Use only #16 gage copper wiring when connecting terminal blocks.
6
1 1
RUGGEDCOM M2200
Installation Guide
1 1
2
2
Connecting Power
Advertisement
Table of Contents
