Panasonic AG-HVX200AP Operating Instructions Manual page 109

RECORDING SETUP screen (continued)
Display
Item
mode
1394 UB REGEN (MCR/
P2 TAPE VCR)
UB MODE (Camera)
P2 TAPE
(MCR/
VCR)
(DUB)
UB PRESET (Camera)
P2 TAPE
(MCR/
VCR)
(DUB)
(MCR/
1394 IN PRESET
P2 TAPE
VCR)
Selects the user information used when recording the signals from equipment
connected to the 1394 terminal.
ON:
Records using the user information of the signal input through the 1394
terminal.
OFF:
Records using the user information set in UB MODE.
• If you select ON here, this has priority over the setting in UB MODE.
• The user information is recorded only when the signal contains the user
information.
• If there is no input to the 1394 terminal, the camera follows the UB MODE
settings.
Set the content for user information.
USER: Records the information of user.
TIME: Records the time at recording.
DATE: Records the date at recording.
TCG: Records the values of the time code generator.
FRM. RATE: Records the frame rate information for frame conversion.
a b c
a:Checking information for user information
b:Frame sequence No.
• 0 to 4 are displayed in the 24P/24P (ADV) mode.
• F is displayed in the 60i/30P mode.
c:Frame rates
• Frame rate (60/30/24)
• I/P ID
• Conversion data
• Frame rate coefficient
d:Recording management data
• Frame update information
• REC START/STOP information
<Note>
To play back a clip recorded with native recording
To change 1394 output user information to frame rate information, change this
setting to FRM.RATE and play back the clip. The user information displayed on
the screen at this time is changed to frame rate information.
Sets the user information. Select USER in UB MODE.
Synchronizes the internal TCG value with the TC of 1394 input when you press
the TC SET button.
ON: The synchronization mode is on.
OFF: The synchronization mode is off.
Description of settings
d
indicates the factory setting.
109