DigiTech HardWire V-10 Owner's Manual page 3

WARNING FOR YOUR PROTECTION READ THE FOLLOWING:
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS
THE APPARATUS SHALL NOT BE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO
OBjECT FILLED WITH LIqUID, SUCH AS vASES, SHALL BE PLACED ON THE APPARATUS
CLEAN ONLY WITH A DRY CLOTH.
FOR INDOOR USE ONLY.
DO NOT BLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH
THE MANUFACTURER'S INSTRUCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES,
OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG
PERIODS OF TIME.
do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
two blades with one wider than the other. A grounding type plug has two blades and a third
grounding prong. the wide blade or third prong are provided for your safety. if the provided
plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet.
protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
use only with the cart stand, tripod bracket, or table specified by the manufacture, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
refer all servicing to to qualified service personnel. servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
POWER ON/OFF SWITCH: For products provided with a power switch, the power switch does
Not break the connection from the mains.
MAINS DISCONNECT: the plug shall remain readily operable. For rack-mount or installation
where plug is not accessible, an all-pole mains switch with a contact separation of at least 3
mm in each pole shall be incorporated into the electrical installation of the rack or building.
FOR UNITS EqUIPPED WITH ExTERNALLY ACCESSIBLE FUSE RECEPTACLE: replace fuse
with same type and rating only.
MULTIPLE-INPUT vOLTAGE: this equipment may require the use of a different line cord,
attachment plug, or both, depending on the available power source at installation. connect
this equipment only to the power source indicated on the equipment rear panel. to reduce
the risk of fire or electric shock, refer servicing to qualified service personnel or equivalent.
if connected to 240V supply, a suitable csA/uL certified power cord shall be used for this supply.