Panasonic AG-HMC70P Operating Instructions Manual page 87

7
Select the layout setting on
[PAGE LAYOUT].
[STANDARD]: Layout specific to the printer
[ ]: No frame print
[ ]: Frame print
≥You cannot set page layouts not supported on
the printer.
8
Select [PRINT]
the center of the cursor button to
print the pictures.
≥Exit PictBridge by disconnecting the USB cable
(optional) after the pictures have been printed.
[YES] and press
#
When you stop printing halfway
Move the cursor button down.
A confirmation message appears. If [YES] is
selected, the number of prints set is canceled
and the screen returns to step 2. If [NO] is
selected, all the settings are kept and the screen
returns to step 3.
≥Avoid the following operations during printing.
These operations disable proper printing.
– Disconnecting the USB cable
– Removing the SD card
– Switching the mode dial
– Turning off the power
≥Check the settings for the paper size, print
quality etc. on the printer.
≥The edges of still pictures recorded on this unit
with a 16:9 aspect ratio may be cut at printing.
When using a printer with a trimming or
borderless printing function, cancel this
function before printing. (Refer to the operating
instructions of the printer for details.)
≥You may not be able to print still pictures
recorded with other products.
≥When the unit is connected directly to the
printer, the DPOF settings cannot be used.
≥Connect the printer directly to this unit. Do not
use a USB hub.
≥Use a USB cable with a USB logo mark, whose
length is 1 m or less.
With other products
87