Cautions For Use - Panasonic AG-HMC70P Operating Instructions Manual

Panasonic memory card camera-recorder operating instructions
Table of Contents

Advertisement

Cautions for use

About this unit
The unit and the SD card become warm during
use. This is not a malfunction.
Keep this unit as far away as possible from
electromagnetic equipment (such as
microwave ovens, TVs, video games etc.).
≥If you use this unit on top of or near a TV, the
pictures and sound on this unit may be
disrupted by electromagnetic wave radiation.
≥Do not use this unit near cell phones because
doing so may result in noise adversely affecting
the pictures and sound.
≥Recorded data may be damaged, or pictures
may be distorted, by strong magnetic fields
created by speakers or large motors.
≥Electromagnetic wave radiation generated by
microprocessors may adversely affect this unit,
disturbing the pictures and sound.
≥If this unit is adversely affected by
electromagnetic equipment and stops
functioning properly, turn the unit off and
remove the battery or disconnect AC adaptor.
Then reinsert the battery or reconnect the AC
adaptor and turn the unit on.
Do not use this unit near radio transmitters or
high-voltage lines.
≥If you record near radio transmitters or
high-voltage lines, the recorded pictures and
sound may be adversely affected.
Make sure to use the supplied cords and
cables. If you use optional accessories, use
the cords and the cables supplied with them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥If the unit is sprayed with such chemicals, its
body may be marred and the surface finish may
peel off.
≥Do not leave rubber or plastic products in
contact with the unit for a long time.
10
When you use the unit in a sandy or dusty
place such as a beach, do not let sand or fine
dust get into the body and terminals of the unit.
Also, keep the unit away from sea water.
≥Sand or dust may damage the unit. (Care
should be taken when inserting and removing a
card.)
≥If sea water splashes onto the unit, wipe off the
water with a well wrung cloth. Then wipe the
unit again with a dry cloth.
When carrying the unit, do not drop or bump it.
≥A strong impact can break the unit's casing,
causing it to malfunction.
Do not use benzine, paint thinner or alcohol
for cleaning the unit.
≥Before cleaning, detach the battery or pull out
the AC cable from the AC outlet.
≥The camera body may be discolored and the
surface finish may peel off.
≥Wipe the unit with a soft dry cloth to remove
dust and fingerprints. To remove stubborn
stains, thoroughly wring a cloth that has been
soaked in a neutral detergent diluted with water
and wipe the unit with it. Afterwards, wipe it
with a dry cloth.
≥When you use a chemical dust cloth, follow the
instructions that came with the cloth.
Do not use the unit for surveillance purposes, etc.
≥If you use the unit for a long time, heat will build
up inside it and this may cause a malfunction.
When you are not going to use the unit for an
extended time
≥When storing the unit in a cupboard or cabinet,
it is recommended that you place a desiccant
(silica gel) in with it.
Caution regarding laser beams
≥The CCD may be damaged if it is subjected to
light from a laser beam.When using the
camera-recorder in locations where laser
irradiation equipment is used, be careful not to
allow the laser beam to shine directly on the
lens.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents