Use The External Microphone Or Audio Devices Connected To The Xlr Terminal - Panasonic AG-HMC70P Operating Instructions Manual

Use the external microphone
or audio devices connected to
the XLR terminal.
1
Connect the external microphone
or an audio device to the XLR
CH1/CH2 terminal (XLR 3-pin)
CH1
AAn external microphone or an audio device
2
Switch the connected audio input
signal using the input level select
switch
AMicrophone attenuation switch
BInput level select switch
LINE:Select when an audio device is
connected.
≥The input level is 0 dBu.
MIC:The ALC (Auto Level Control) function
is disabled. The audio recording level
can be adjusted with the AUDIO LEVEL
knob.
≥The input level is -50 dBu/-60 dBu.
≥Switch the input level by using the
microphone attenuation switch. When
the microphone attenuation switch is
turned ON, the input level is -50dBu.
However, when the level is set to OFF,
CH2
the sensitivity increases, which may
introduce noise into the recording.
3
Set the input level select switch
to +48V to use a phantom
microphone (a microphone that
requires the +48V power supply).
+48V:When a phantom microphone is
connected
≥+48V power is supplied to the XLR
CH1/CH2 terminal.
≥The battery will discharge faster when
a phantom microphone is used.
≥When connecting a device that does
not support the +48V power supply,
set the switch to LINE or MIC. Setting
the switch to +48V may cause the
connected device to fail.
4
Set the CH1 switch to REAR
Audio from the device connected to the XLR CH1
terminal is recorded.
5
Set the CH2 switch to REAR
Audio from the device connected to the XLR CH2
terminal is recorded.
4
Recording
5
59