Staple Sort Mode - Toshiba e-STUDIO557 Copying Manual

3.BASIC COPY MODES

Staple sort mode

When you make more than one set of copies, the copied paper can be automatically stapled set by set. This
mode is called the staple sort mode. You can choose from 3 different stapling positions.
Example: When [FRONT STAPLE] is selected
Special paper such as OHP film or sticker labels is not applicable.
Copies in different sizes cannot be stapled. (If the lengths of the copies are the same, they can be
stapled.)
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Place the original(s).
3
Press [FINISHING] on the touch panel.
4
Select the desired stapling position from [FRONT STAPLE], [DOUBLE STAPLE] or
[REAR STAPLE], and then press [OK].
5
Select other copy modes as required, and then press the [START] button on the control
panel.
When the number of sheets exceeds the maximum number of sheets available for stapling, this
equipment automatically enters into the sort mode.
3 BASIC COPY MODES
Selecting Finishing Mode 67