Compaq Presario 7360 Maintenance And Service Manual page 8

Product Description
Home
Replacement
PRODUCT DESCRIPTION
Power cord
set
requirements
Power Cord Set Requirements
Models and
The power cord set (flexible cord and wall plug) received with the computer
Features
meets the requirements for use in the country where the computer was
purchased.
CPU controls
and lights
Power cord sets for use in other countries must meet the requirements of the
country where you use the computer. For more information on power cord
Keyboard
set requirements, contact your Compaq authorized dealer, reseller, or
controls and
service provider.
lights
General Requirements
Rear CPU
connectors
The requirements listed below are applicable to all countries:
Country-Specific Requirements
Maintenance and Service Guide
Compaq Presario 7300 Series Computers
Removal &
1 The length of the power cord set must be at least
6.00 feet (1.8 m) and a maximum of 9.75 feet (3.0
m).
2 All power cord sets must be approved by an
acceptable accredited agency responsible for
evaluation in the country where the power cord set
will be used.
3 The power cord set must have a minimum current
capacity of 10A and a nominal voltage rating of 125
or 250 volts AC, as required by each country's power
system.
4 The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector, for mating with appliance inlet
on the Switch Box.
Country
United States
* The flexible cord must be Type SJT-2 or equivalent, No. 18
AWG, 3-conductor. The wall plug must be a two-pole
grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-
15P (15A, 250V) configuration.
Troubleshooting
Jumper & Switch
Information
Illustrated Parts
Catalog
Specifications
Accredited Agency
UL*