Alcatel-Lucent OAW-AP120 Installation Manual page 7

Alcatel-Lucent WLAN Switch. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet)
long.
N O T E
The 100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female
connectors with the pin-outs shown in
Table 1 Connector for Ethernet Ports ENET0 and ENET1
Connector
Serial Console Port
The serial console port allows you to connect the AP to a serial terminal or a laptop for direct local
management. This port is an RJ-45 female connector with the pinouts described in
port in one of the following ways:
Connect it directly to a terminal or terminal server using an Ethernet cable.
Use a modular adapter to convert the RJ-45 (female) connector on the AP to a DB-9 (male)
connector, and connect the adapter to a laptop using an RS-232 cable. See
details of the adapter.
Table 2 Connector for Serial Console Port
Connector
Alcatel-Lucent OAW-AP120 Series Indoor Access Point
Alcatel-Lucent OAW-AP12x APs are intended only for installation in Environment A as defined in
IEEE 802.3.af, Power over Ethernet. All interconnected equipment must be contained within the
same building, including the interconnected equipment's associated LAN connections.
Signal
Pin
Name
1 BI_DA+ Bi-directional pair A+
1
2 BI_DA–
2
3
3 BI_DB+ Bi-directional pair B+ TX+
4
4 BI_DC+ Bi-directional pair C+ Spare pair
5
6
5 BI_DC– Bi-directional pair C–
7
6 BI_DB–
8
7 BI_DD+ Bi-directional pair D+ Spare pair
8 BI_DB–
Pin Signal Name
3 TXD
1
2
4 GND
3
4
5 GND
5
6 RXD
6
7
Pins not listed are not connected.
8
| Installation Guide
Table 1.
FE
GE Connection
Connection
RX+
Bi-directional pair A– RX–
Spare pair
Bi-directional pair B– TX–
Bi-directional pair D– Spare pair
Function
Transmit
Ground
Ground
Receive
PoE
POE negative
POE negative
POE positive
POE positive
POE positive
POE positive
POE negative
POE negative
Table 2. Connect this
Figure 7 for connector
7