Connecting Required Cables - Alcatel-Lucent OAW-AP120 Installation Manual

1. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be
placed.
2. If necessary, connect the console cable to the console port on the back of the AP.
3. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-
degree angle to the ceiling tile rail (see
tile.
Figure 5 Orienting the Ceiling Tile Rail Mounting Slots
4. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into place on the
ceiling tile rail.
5. On the OAW-AP121 or OAW-AP125, orient the antennas. For best results, rotate the antennas so that
they are vertical (perpendicular to the body of the AP) (see
Figure 6 Antenna Orientation on a Ceiling-Mounted OAW-AP121/OAW-AP125
On the OAW-AP120 or OAW-AP124, install the external antennas according to the manufacturer's
instructions, and connect the antennas to the antenna interfaces on the AP (see

Connecting Required Cables

Install cables in accordance with all applicable local and national regulations and practices.
Ethernet Ports
The RJ45 Ethernet ports (ENET0 and ENET1) support 100/1000Base-T auto-sensing MDI/MDX
connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to an
6
Figure 5). Make sure that any cable slack is above the ceiling
Figure
Alcatel-Lucent OAW-AP120 Series Indoor Access Point
ap1
6).
Figure 4).
| Installation Guide