Operations; Powering On The Switcher - Extron electronics SW HD 4K series User Manual

F

Operations

Powering on the Switcher

To power on the SW HD 4K:
1.
2.
3.
4.
NOTE: If the source device connected to the selected input is HDCP
encrypted (requires HDCP authentication), the corresponding signal LED
may not light unless HDCP has been authenticated.
Output — Two LEDs for the SW2 HD 4K and four for the SW4 HD 4K. The
•
Output Signal LED lights when an active sink (output) device is connected to the
HDMI output.
The input buttons are also used to initiate a system reset (see
and to enable and disable front panel lockout (see
Front Panel (Executive Mode)
HDCP status LEDs (see figure 9
Inputs — Each input has a corresponding numbered HDCP LED. If the
•
connected source requires HDCP, the corresponding LED lights when
authentication is successful.
NOTE: HDCP is authenticated on each input regardless of the currently
selected source.
Output — The Output HDCP LED lights if the currently selected input requires
•
HDCP and the connected output device has been successfully authenticated.
NOTE: HDCP is re-authenticated on the output whenever a new input is
selected.
Connect all input and output devices to the rear panel connectors on the switcher
(see Rear Panel Features
Power on the display.
Power on the SW HD 4K: Plug the power supply into the 2-pole captive screw
power connector on the switcher rear panel.
After approximately 4 seconds, the following happens:
The unit performs a self-test, during which the front panel Auto Switch, Input,
•
Signal, and HDCP LEDs each blink once in sequence from left to right. When the
self-test completes, the LED for the most recently selected input remains lit.
The switcher reads the available EDID information from the connected output
•
device and writes it to memory on each input. When power is removed, these
settings remain in memory and are in effect when power is reapplied.
ATTENTION:
•
Do not connect any external power supplies until you have read the
notifications
on page 6.
•
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les mises en
garde sur la page 6 .
Power on the input devices.
Locking and Unlocking the
on page 15).
on the previous page)
on page 4 for the rear panel connections).
SW HD 4K Series • Operation
Resetting on page 14)
Attention
13