10. DECORATION PANEL INSTALLATION
Refer to the installation manual of the panels.
[ PRECAUTIONS ]
• SWING FLAP MOTOR WIRING METHOD
(1) CONNECT TWO LEAD WIRES OF SWING FLAP MOTOR MOUNTED ON THE DECORATION PANEL
TO THE CONNECTORS OF MAIN BODY.
(2) SLIDE THE INSULATION TUBE ACCORDING TO THE ARROW AS SHOWN IN FIG. SO THAT THE
CONNECTOR CAN BE COMPLETELY COVERED. (ONLY HIGH VOLTAGE SIDE)
(3) BIND THE OPENING OF INSULATION TUBE WITH THE ATTACHED CLAMP MATERIAL.
11. TEST OPERATION
Refer to the installation manual of the outdoor unit.
• The operation lamp of the remote controller will flash when an error occurs. Check the error code on the liq-
uid crystal display to identify the point of trouble. An explanation of error codes and the corresponding trou-
ble is provided in "CAUTION FOR SERVICING" of the indoor unit.
17
CLAMP MATERIAL
(ATTACHED PART)
English