Wiring Example And How To Set The Remote Controller - Panasonic CS-25DM1HPK Installation Manual

9. WIRING EXAMPLE AND HOW TO SET THE REMOTE CONTROLLER

9-1 HOW TO CONNECT WIRINGS
• Refer to the figure below when connecting the remote controller wiring with transmission wiring and power
supply wiring
Wire clip
Attached
clamp
Remote controller
wire and
connecting wire (∗)
Rubber bush
• You can temporarily hang the electric parts box of the unit from the position shown in the figure below. Use
according to the type of work.
CAUTION
• When cramping wiring, use the included cramping material to do an appropriate cramp to prevent undue
pressure on the wiring connections. When carrying out the wiring, bundle the wires to prevent the switch
box lid from lifting, and attach the lid firmly. When attaching the switch box avoid getting wires caught always
use a wiring through-lid to prevent damage to the wires.
• Make sure to avoid external force to the field wiring(∗) such as by laying them in protection pipes or in the
wall.
English
Power supply
Electric parts box
terminal board
(NOTE 1)
Ground wire (∗)
Electric parts
box lid
Terminal board for unit
transmission wirings
(NOTE 2)
NOTE 1: Details of terminal block for power supply
Plastic clamp
NOTE 2: Details of terminal board for unit
transmission wirings
Wiring
berween
Remote controller wiring
units (∗)
(Field wiring)
Plastic
clamp
Clamp
(Attached)
Electric parts box
Power supply wiring
(Field wiring)
Transmission wiring
between units
(Field wiring)
T2 T1 F2 F1 P2 P1
Electric parts box
12