Panasonic HDC-SX5P Operating Instructions Manual page 141

Problem
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
The remote control does
not function.
The message "DISC
DOOR OPENED."
appears although the
disc cover is closed.
The DISC EJECT lever
does not work.
The screen has changed
suddenly.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥ The unit cannot be operated unless you open the LCD monitor or
extend the viewfinder.
≥ Press the RESET button. (l 145) If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above operation
when the access lamp is on may destroy the data on the disc or SD
card.)
≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 22)
≥ This message may appear if the battery is removed or the AC
adaptor is disconnected while removing a disc or before the power
to the unit fully turns off.
# Open the disc cover with the DISC EJECT lever and then close it
again.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is connected to
the computer.
# Disconnect the USB cable.
≥ Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or an
SD card in recording mode, the unit is automatically set to the
demonstration mode for introducing its functions. Normally this
should be set to [OFF]. Press the MENU button, then select
[SETUP] # [DEMO MODE] # [OFF] and press the cursor
button.
≥ If you set [SETUP] > [DISPLAY] > [OFF], all indications other
than warnings and date are not displayed.
Check points
Others
141
VQT1J42