Table of Contents
Advertisement
Setup menu list (continued)
RECORDING SETUP screen
Item/
(Display
mode)
REC SPEED
Set the recording-time mode.
(camera)
SP: SP (standard) mode
(VCR)
LP: LP (long) mode
AUDIO REC
Set the audio recording mode for con-
(camera)
version to PCM audio.
(VCR)
32K (12bit): 12bit/21kHz
48K (16bit): 16bit/48kHz
MIC ALC
Sets microphone level auto control to
(camera)
ON or OFF.
ON OFF
Set this ON to reduce distortion at high
input levels.
• You should also adjust the input level
with the AUDIO control whatever you
set here.
MIC GAIN 1
Sets the input level of the external
(camera)
microphone connected to the INPUT 1
terminal.
-50dB -60dB
MIC GAIN 2
Sets the input level of the external
(camera)
microphone connected to the INPUT 2
terminal.
-50dB -60dB
1394 TC
Selects the time code used when sig-
REGEN
nals from equipment connected with
(VCR)
the DV terminal is recorded.
ON:
Records with the time code signal
input through the DV terminal.
OFF:
Records with the time code set at TC
MODE/TCG/FIRST REC TC.
• This setting has priority over any
setting you have made in TC MODE/
TCG/FIRST REC TC.
• If there is no input to the DV terminal,
the setting follows the ones set at TC
MODE/TCG/FIRST REC TC.
TC MODE
Selects the correction mode of the
(camera)
internal time code generator.
(VCR)
DF
NDF
• The non-drop frame mode will be
used when you are shooting in a
progressive mode, 24P or 24P (ADV).
74
Description of settings
: Uses the drop frame mode.
: Uses the non-drop frame
mode.
Item/
(Display
Description of settings
mode)
TCG
Use this to set the mode in which to
(camera)
advance the time code.
(VCR)
FREE RUN:
The time code advances regardless
of the operation mode.
REC RUN:
The time code advances only when
recording.
FIRST REC TC
Select the time code to be recorded
(camera)
when you start recording.
(VCR)
REGEN:
Select to record the time code so
that it continues from the time code
already on the tape.
PRESET:
The time code does not continue
from the time code on the tape. The
value you set at TC PRESET is used
as the initial value when recording
the time code. The time code does
continue on from the one on the
tape, however, if you continue
recording from something on the
tape.
TC PRESET
Sets the initial time code. This is
(camera)
effective when you have select
(VCR)
PRESET in FIRST REC TC.
• Set the frame value to 0 or a multiple
of 5 when you are shooting in a
progressive mode, 24P or 24P (ADV).
Using any other value will cause the
time code to differ.
1394 UB
Selects the user information used
REGEN
when signals from equipment con-
(VCR)
nected with the DV terminal is
recorded.
ON:
Records with the user information
signal input through the DV terminal.
OFF:
Records the user information set
with UB MODE.
• If you select ON here, this has priority
over the settings in UB MODE.
• If the signal has no user information,
the none is recorded.
• If there is no signal being input
through the DV terminal, then the UB
MODE settings are used.
is the factory setting.
Advertisement
Table of Contents
