Table of Contents
Advertisement
Cable Compensation Unit AW-RC400
Introduction
≥ The AW-RC400 is capable of providing cable
compensation for analog composite, analog Y/C or analog
component signals in five channels up to 500 meters
(when the BELDEN 8281 connecting cable or its
equivalent is used).
≥ It features a 5µs advance function for the sync signals in
order to provide easy support for a system (another cable
compensation unit is required) in which the coaxial cable
connected between this AW-RC400 cable compensation
unit and the camera is longer than 500 meters.
Accessories
Rack-mounting adaptors ............................................................. 2
Mounting screws (M4!8 mm) .................................................... 4
NOTE
≥ Input either sync signals to the sync signal input
connector on the AW-RC400 cable compensation unit
or input video signals to one of the video channels
(input composite signals or Y signals with sync to video
input connector 1). If neither of these signals is input,
the monitor selection will not be controlled.
≥ The AW-RC400 provides cable compensation for the
three Y, Pr and Pb signal channels by means of a
single control. This means that the Y, Pr and Pb signals
cannot be adjusted separately. In the same way, the Y
and C signals cannot be adjusted separately.
≥ The AW-RC400 is a cable compensation unit and, as
such, it does not come with signal conversion functions
(for converting component signals into composite
signals, for instance).
≥ When the cable compensation unit is to be discarded at
the end of its service life, ask a specialized contractor
to dispose of it properly in order to protect the
environment.
38
Advertisement
Table of Contents
