Introduction; Accessories; Aw-Rc400 Cable Compensator - Panasonic AW-RC400E Operating Instructions Manual

Cable Compensator AW-RC400

Introduction

≥ The AW-RC400 is capable of providing cable
compensation for analogue composite, analogue Y/C or
analogue component signals in five channels up to 500
meters (when the 5C-2V connecting cable or its
equivalent is used).
≥ It features a 5us advance function for the sync signals in
order to provide easy support for a system (another cable
compensator is required) in which the coaxial cable
connected between this AW-RC400 cable compensator
and the camera is longer than 500 meters.

Accessories

Rack-mounting adaptors ............................................................. 2
Mounting screws (M4!8 mm) .................................................... 4
NOTE
≥ Input either sync signals to the sync signal input
connector on the AW-RC400 cable compensator or
input video signals to one of the video channels (input
composite signals or Y signals with sync to video input
connector 1). If neither of these signals is input, the
monitor selection will not be controlled.
≥ The AW-RC400 provides cable compensation for the
three Y, Pr and Pb signal channels by means of a
single control. This means that the Y, Pr and Pb signals
cannot be adjusted separately. In the same way, the Y
and C signals cannot be adjusted separately.
≥ The AW-RC400 is a cable compensator and, as such,
it does not come with signal conversion functions (for
converting component signals into composite signals,
for instance).
≥ When the cable compensator is to be discarded at the
end of its service life, ask a specialized contractor to
dispose of it properly in order to protect the
environment.
35 (E)