5. 1" Hole saw or equiv. INSTALLATION INSTRUCTION # 44-0048A INSTALLATION INSTRUCTIONS 50-0312x SERIES 1181338 2. Powered screwdriver or drill with adapter 4. Razor knife or similar 6. Audiovox VCP (AVP-7180 or equiv.) Nov. 8, 1999 Printed in the U.S.A...
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 8 X 3/4" PPH VCP MOUNTING BRACKET VELCRO TAPE, 1" X 10" VELCRO TAPE, 1" X 5" VCP COVER INSTALLATION INSTRUCTION # 44-0048A Nov. 8, 1999 Printed in the U.S.A.
Page 3
I. PREPARATION OF VEHICLE INTERIOR FIGURE 1 4. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar.
Page 4
6. Align slot in VCP mounting bracket (item 2 pg 2) with existing hole in floor of vehicle. See Figure 4. FIGURE 5 8. Remove and discard (2) two screws from the right side of VCP. See Figure 6. 9. Apply 10" Velcro tape (item 3 pg 2) to top rear of VCP.
Page 5
FIGURE 7 14. Install VCP cover (item 5 pg 2). Make sure that Velcro tape adheres to cover. See Fig. 8. FIGURE 9 11. Remove protective backing from Velcro tape and insert VCP into mounting bracket (item 2 pg 2) as shown in Figure 7.