Table of Contents
Advertisement
Chapter 7 Menu description tables
7-2-2 OPTION MODE
Item/
Variable
Data storage
range
P.OFF GPS DATA
HOLD
For selecting whether or not to hold the UMID
CLEAR
GPS position information while the power is
off and record the information as the data still
held as the previous value until another
measurement can be taken after the power is
next turned on.
HOLD: The data is held and recorded.
CLEAR: The data is cleared at the same time
C U F
COMPONENT OUT ON
For selecting whether to conserve the power
OFF
of the component output to peripheral units.
ON: Component signals are output to the
OFF: Output stops during power save. (Note
C U F
1394 SPEED
S100
For setting the transfer speed of the signals to
S200
be output from the DVCPRO connector.
S400
S100: 100 Mbps
S200: 200 Mbps
C U F
S400: 400 Mbps
1394 IN CH
0
For setting the input channel for the signals to
:
be supplied to the DVCPRO connector.
63
0-63:
AUTO
The channel is fixed at the specified
number.
AUTO:
The channel corresponding to the setting of
the externally connected unit is selected.
C U F
1394 OUT CH
0
For setting the output channel for the signals
:
to be output from the DVCPRO connector
63
0-63:
AUTO
The channel is fixed at the specified
number.
AUTO:
The channel corresponding to the setting of
the externally connected unit is selected.
C U F
26PIN VIDEO
COMPONENT
For setting the video signals to be output from
SELECT
VIDEO OUT
pin #4 of the 26-pin connector when a 26-pin
camera adapter is connected.
COMPONENT:
The component Y signal is output.
VIDEO OUT:
The same signal (composite signal) as the
VIDEO OUT connector signal is output.
C U F
The underlining in the variable range column indicates the setting in the preset
mode.
82
Remarks
as the power is turned off, and all
zeros (no information) are recorded
from the time the power is turned on
until the measurement is next taken.
peripheral units.
that this setting is forced ON if a
camera adapter is connected and a
tally signal is detected from pin 26.
Otherwise it is OFF.)
Item/
Variable
Data storage
range
26PIN CONTROL
OFF
For setting whether recording is to be
BOTH
controlled by the unit or by both the unit and
the external VTR which is connected to the
26-pin camera adapter.
OFF:
Recording is performed by the unit only. (It
is not performed using the external VTR.)
BOTH:
Recording is performed by both the unit
and the external VTR.
indicates the status of the tally signal of the
26-pin connector. (The tally lamp setting
can be established using REC TALLY in
the SYSTEM MODE.)
C U F
26PIN CTL
NORMAL
For setting the control signal of the VTR to be
DEFAULT
SPECIAL
output from pin #12 of the 26-pin connector
when using a VTR connected to a 26-pin
camera adapter.
NORMAL:
STOP "low," START "high" (for AJ-D92)
SPECIAL:
STOP "high," START "low"
C U F
Remarks
The tally lamp
Hide quick links:
Advertisement
Table of Contents
