Automatic Number Identification (Ani) - Baofeng uv-82 Operating Manual

Automatic Number Identification (ANI)

In most dispatch environments it is common to have a system that allows radios to automatically identify themselves to the
dispatcher. This is known as Automatic Number Identification (AIN), or PTT-ID, due to the radio sending a data burst containing
the ID code at the beginning or end of a transmission. The Baofeng UV-82 uses DTMF signaling to enable ANI implementation.
Procedure: Setting ANI/PTT-ID Code
1. Attach the radio to the computer and open the Baofeng PC software. See "Computer Programming" section for more
details.
2. In the Edit menu, select DTMF. This will open up a window called DTMF Encode/Decode.
3. Go to the Program menu, select Read from Radio and the Read from Radio window will open.
4. Click the Read button. The status LED on the radio will flash red indicating the transmission of data.
5. Locate the box named ANI Code and enter any relevant ANI code details into this text field.
a. If group ID codes are used instead of personal ID codes, it is possible to enter up to 15 of them in the list on the
left in the DTMF Encode/Decode window. These can be assigned on a channel by channel basis in the Channel
Information field.
6. Check the Press PTT to Send box to transmit ID prior to regular transmission.
7. Check the Release PTT to Send box to transmit ID after regular transmission.
8. In the Program menu, select Write to Radio and the Write Data to Radio window will open.
9. Click the Write button. The status LED on the radio will flash green indicating that it's receiving data.
To fully enable ANI settings, there are a few more steps. The directions below assume that the radio is still connected to the PC,
and that the software is running.
Procedure: Enabling/Disables/Configuring ANI Settings
1. In the Edit menu, select Optional Features. This will open up a window called Optional Features.
2. Go to the Program menu, select Read from Radio and the Read from Radio window will open.
3. Click the Read button. The status LED on the radio will flash red indicating the transmission of data.
4. Use the PTT-ID drop-down list to select the position of both the ANI data burst; BOT (Beginning of Transmission), EOT
(End of Transmission), or BOTH. To turn ANI off completely, select OFF from the drop-down list.
5. In the Program menu, select Write to Radio and the Write Data to Radio window will open.
6. Click the Write button. The status LED on the radio will flash green indicating that it's receiving data.
After these two procedures, the radio should be set up for ANI.
http://www.baofengradio.us
http://baofengradio.us
39