Connection And Recognition; Connection And Recognition Procedures - Panasonic AG-HSC1UP Operating Instructions Manual

Connection and recognition

Connection and recognition
procedures
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognized by the computer.
≥Connect after installing the software
applications.
≥Remove the supplied CD-ROM if it is inserted
in the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
1
Insert the battery and connect
the AC adaptor.
≥If you do not insert the battery and connect
the AC adaptor, operation will not be
possible after connecting this unit to the
computer.
2
Insert an SD card with recorded
images in this unit and then set
the mode dial to
the power.
to turn on
3
Connect this unit and a
computer.
A USB cable (supplied)
This unit is automatically recognized by the
computer.
≥Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
≥When the unit is connected to a computer,
the operation mode cannot be changed and
its power cannot be turned off.
In this case, disconnect the USB cable
(l 101).
≥When a computer is accessing the SD card in
this unit, the card access lamp lights. (When a
card is being accessed,
LCD monitor.) Do not disconnect the USB
cable or AC adaptor while the card is being
accessed as it may damage the data.
≥It may be necessary to reboot the computer
after connecting this unit to it for the first
time.
With a computer
A
appears on the
99
VQT1F36