Remote Control Usable Range - Panasonic AG-HSC1UP Operating Instructions Manual

ª Install a button-type battery
Install the supplied button-type battery in the
remote control before using it.
1
While pressing the stopper A,
pull out the battery holder.
2
Set the button-type battery with
its (i) mark facing upward and
then put the battery holder back
in place.
Concerning the button-type battery
≥When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery should normally last
about 1 year, however this depends on how
frequently the unit is used.
≥Keep the button-type battery out of the reach of
children.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
Replace battery with Panasonic PART NO.
CR2025 only. Use of another battery may
present a risk of fire or explosion.
Caution: Battery may explode if mistreated.
Dispose of used battery promptly. Keep away
from children.
Do not recharge, disassemble or dispose of in
fire.
A
ª Remote control usable range
The distance between the remote control and the
unit's remote control sensor A: Within approx.
5 m (16 feet)
Angle: Approx. 10o up and 15o down, left, and
right
≥The remote control is intended for indoor
operation. Outdoors or under strong light, the
unit may not operate properly even within the
usable ranges.
Before using
A
25
VQT1F36