Connecting To The Ac Outlet; Vqt1F36 - Panasonic AG-HSC1UP Operating Instructions Manual

ª About the remaining battery
capacity indication
The remaining battery capacity is displayed in
minutes when using the Panasonic battery that
you can use for this unit. It may take time to
display the remaining battery capacity.
≥The display changes as the battery capacity
reduces.
# #
If there is less than 3 minutes remaining, then
will become red. If the battery
discharges, then (
≥The remaining battery capacity may not be
displayed correctly where the temperature is
low or high or if the battery was not used for a
long period of time.
To correctly display the remaining battery
capacity, recharge the battery, discharge it and
then charge it again. (Even if this operation is
performed, it may not be possible to display the
remaining battery capacity correctly if the
battery was used for a long period of time
where the temperature is low or high or if the
battery was repeatedly charged.)
≥The times of remaining battery capacity
indication will vary depending on the status of
use. These times are approximations.
≥When turning the mode dial to switch modes,
the time indication will turn off in order to
recalculate the remaining battery capacity time.
≥When using batteries made by other
companies, the remaining battery capacity will
not be shown.
30min
# # .
) will flash.

Connecting to the AC outlet

≥Even if the battery is inserted in this unit, it
will not charge.
1
Connect the AC cable to the AC
adaptor.
2
Connect the DC cable to the AC
adaptor.
3
Open the terminal cover on this
unit and connect the DC cable to
the DC input terminal
[DC IN 9.3V].
≥Do not use the AC cable with any other
equipment as it is designed only for this
unit. Do not use the AC cable from other
equipment with this unit.
≥Put the battery on the AC adaptor to charge it.
(l 28)
≥While the DC cable is connected to the AC
adaptor, the battery will not charge.
Setup
DC IN 9.3V
31

VQT1F36