Running Post - Cisco WS-C2950-24 Hardware Installation Manual

Chapter 2 Installation
Figure 2-24 Inserting the Terminal Block in the Block Header
36 - 72 V
D C IN PU
1 - 0. 5A
T FO R R
PO W ER
SP EC IF
IE D IN M
A
+1 2V @
B
Tie wrap
Step 8

Running POST

Note
78-11157-02
EM O TE
SU PP LY
AN UA L.
4. 5A
C O N SO
Remove the tape from the circuit-breaker switch handle, and move the
circuit-breaker handle to the on position.
After the power is connected, the switch automatically begins POST, a series of
tests that verifies that the switch functions properly. When the switch begins
POST, the system LED is off. If POST completes successfully, the LED turns
green. If POST fails, the LED turns amber. See
determine a corrective action.
POST failures are usually fatal. Call Cisco Systems immediately if your
switch does not pass POST.
LE
Catalyst 2950 Desktop Switch Hardware Installation Guide
Running POST
Chapter 3, "Troubleshooting," to
2-29