Cisco WS-C2950-24 Hardware Installation Manual page 66

Connecting to DC Power
To ground the switch to earth ground, follow these steps. Make sure to follow any
grounding requirements at your site.
Locate the ground lug and the two number-10-32 screws.
Step 1
If your ground wire is insulated, use a wire stripping tool to strip the 6-gauge
Step 2
ground wire to 0.5 inch ± 0.02 inch as shown in
Figure 2-15 Stripping the Ground Wire
Slide the open end of the ground lug over the exposed area of the 6-gauge wire.
Step 3
Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire.
Step 4
Figure 2-16 Crimping the Ground Lug
Use the two number-10-32 screws to attach the ground lug and wire assembly to
Step 5
the switch rear panel.
Catalyst 2950 Desktop Switch Hardware Installation Guide
2-22
0.50" ± 0.02"
Wire lead
Insulation
Chapter 2 Installation
Figure 2-15.
78-11157-02