Installation Instructions; Electrical Connection - Beko HPD 24400 W Owner's Manual

3

Installation Instructions

A
WARNING - Risk of
fire
• The clothes dryer ("appliance') installa-
tion must be performed by a qualified
installer.
• Install the appliance according to the
manufacturer's instructions and local
codes.
• Do not install a clothes dryer with flex-
ible plastic venting materials. If flexible
metal (foil type) duct is installed, it must
be of a specific type identified by the ap
pliance manufacturer as suitable for use
with clothes dryers. Flexible venting ma-
terials are known to collapse, be easily
crushed, and trap lint. These conditions
will obstruct the clothes dryer's airflow
and increase the risk of fire.
• •To reduce the risk of severe injury or
death, follow all installation instruc-
tions.

3.1 Electrical connection

Connect the appliance to a grounded outlet
protected by a fuse or circuit breaker of suit-
able capacity.
Dryer shipped with cord to fit this
type 4 -wire receptacle
4-wire r eceptacle
(14 -30R)
If yo u have 3-wir e recep tacle, like
this , a 3-wire dryer cord mu st be
purc hased locall y.
3-wire r eceptacle
(10 -30R)
EN / 10
C
Neutral conecction is not used in
this product
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle as
shown below, you must obtain a 3-wire dryer
cord. A dryer cord can usually be found at
your local hardware supply, electrical supply
or home center. Cord should have closed loop
or upturned end wire terminating connec-
tors. The cord kit must be marked "For Use
with Clothes Dryers".
3- wire receptacle
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
If the dryer is installed in a mobile
home, recreational vehicles, new
A
branch-circuit installations or in
areas where local codes do not
permit grounding through the
neutral conductor, only a 4-wire
power supply cord shall be used.
Power Cable
( 10-30R)
Dryer / User Manual