When Moving The Unit - Roland KF-10 Owner's Manual

6.
Use screws (5 x 20) to provisionally fasten
side leg assembly R to the main unit at
three locations, and use a screw (6 x 70) and
a cross dowel to fasten the center board.
Side leg assembly R
7.
Place the main unit upright, and fi nish
tightening the screws that you tightened
provisionally in steps 5 and 6; fi rst tighten
the screws of the side leg assemblies and
then the screws of the center board (eight
locations).
* Ensure that there are no gaps between
the side leg assemblies and the main
unit.
* Take care that the side leg
assembly does not slide
up over the main unit.
* After you have provisionally assembled
the unit, be sure to fi nish tightening the
screws securely.
8.
Use screws (4 x 16) to fasten the headphone
hook.
Screws
4 x 16 mm
9.
Connect the AC adapter to the DC In jack
located on the rear panel of the piano, and
connect the pedal cord to the Pedal jack.
Use the coated clips to secure the pedal
cord and AC adapter cord (three locations).
Screws
5 x 20 mm
Assembling the
Dedicated Bench
1.
From the box containing the accessories,
remove the bench seat leg assemblies (2
pcs.) and the frame.
2.
Use the dowels to connect the frame to
the seat leg assemblies, and use eight
hex socket head cap bolts (6 x 40) to
provisionally fasten them.

When moving the unit

If you need to move the unit, close the keyboard cover and disconnect the AC adaptor and the pedal unit. With at
least one other person helping you, lift the unit horizontally and carry it, taking care not to pinch your hands or
drop the unit on your feet.
3.
Use six hex socket head cap bolts (6 x 40)
to fasten the seat to the parts that you
assembled in step 2.
4.
Stand the bench upright, and securely
tighten all of the bolts.
If the bench wobbles, affi x
the included felt pads to the
bottom of the legs.
* Don't affi x the felt pads if you're using
Hex socket head cap bolt
6 x 40 mm
Hex socket
head cap bolt
6 x 40 mm
the bench on carpet.
11