Installing The Server; Installation Sequence And Checklist; Installing The Server Into A Seismic Rack - HP Carrier-Grade rx2800 i2 Server DC User's & Service Manual

3 Installing the server

This equipment is intended for installation in Network Telecommunication Facilities.
CAUTION:

Installation sequence and checklist

Step Description
1 Perform site preparation (see
2 Install the server into the rack.
3 Connect cables to the server.
a. Connect the DC input power cables.
b. Connect LAN core I/O cables.
c. Connect the iLO 3 MP LAN cable.
4 Connect and set up the console for access.
5 Power on the server.
6 From iLO MP, access UEFI.
7 Boot the operating system.
8 Using HP Smart Update Manager, download the latest firmware

Installing the server into a seismic rack

For information on the installation of the server using the commercial rack mount kit, see the HP
website at http://www.hp.com/support/manuals.
While not specifically designed for use in seismic rack solutions, the commercial kit was successfully
evaluated in the AH343A HP Seismic Rack to the NEBS Zone 4 criteria as part of the rx2800 i2
server NEBS certification.
IMPORTANT:
procedure which pertains only to installing the server into a seismic rack.
18 Installing the server
Before starting this procedure, see
"Site preparation" (page
Perform all the steps in the kit with the exception of the steps specified here in this
"Preventing electrostatic discharge" (page
15)).
25).
Completed