Connecting Your Tg389Ac To Your Service Provider's Network - Technicolor TG389ac Setup And User Manual

2.1 Connecting your TG389ac to your service provider's
network
Introduction
This section helps you to connect your TG389ac to your service provider's network.
Procedure
Proceed as follows:
1 Take an Ethernet cable. If your package contains an Ethernet cable with red connectors, you must use that cable.
If you use another Ethernet cable than the one included in you package, make sure that the Ethernet cable is a
fully wired CAT5E or CAT6 Ethernet cable.
2 Plug one end of the cable in the red WAN port on the back of your TG389ac.
3 Plug the other end of the cable into the Ethernet port of your Internet access device (for example, an optical network
terminal for Fiber).
The WAN port can only be used to connect your TG389ac to an Internet access device. You cannot use it to
connect other devices (for example, a computer) to the TG389ac.
DMS3-CTC-25-154 v1.0
2 Setting up your TG389ac
WAN
14