Remote Control Unit Rc7200Sr; Operation Of Remote Control Unit - Marantz SR7200 User Manual

REMOTE CONTROL UNIT RC7200SR

This chapter describes the functions which need to control the
SR7200. See page 18 and following pages to refer other function of
the RC7200SR.
c POWER ON and OFF
These two buttons are use for turning on or off SR7200.
b LCD
Used to display information about currently selected modes and
functions.
n Jog Dial control
Rotate this dial to select commands displayed on the LCD for each
function. (see page 27)
Refer to follow.
Function Jog Dial command Note
AMP 1 A/D switches analog/digital input
2 ATT switches attenuator for analog input
3 NIGHT selects NIGHT mode for Dolby Digital
4 MR-ON turns multi-room mode on
5 MR-OF turns multi-room mode off
6 7-DIR activates 7-channel input
7 TRB+ increases treble
8 TRB- decreases treble
9 BAS+ increases bass
0 BAS- decreases bass
TUNER 1 FM FM band
2 AM AM/MW band
3 LW Long Wave band
4 T-MOD mono/stereo mode selector
5 SCAN programmed preset channel scan
⊗
6 STM selects station mode
7 F-DIR inputs a frequency directly
8 PTY selects PTY function
9 DISP selects display function
⊗
0 DWR selects DSR wave range
The marked "⊗" commands are not used for SR7200.
m ENT buttons
Press this button to enter the selected command by the Jog Dial.
, FUNCTION buttons
Press one of these buttons twice within 2 seconds to select the input
function of SR7200.
Press one of these buttons once to change the state of remote
commander.
. VOLUME
up /
These buttons are used to raise and lower the SR7200's volume level.
⁄0 CURSOR buttons
The cursor buttons can be used to navigate within on-screen menus of
SR7200.
⁄2 Channel
up /
Used to controls the up/down function of tuner, or allows one to cycle
through the tuner presets.
⁄3 MUTE button
This button can be used to mute the sound temporarily.
⁄5 CLEAR button
This button is used to cancel certain memory or programming
operations.
⁄6 MEMO button
This button is used to enter the tuner preset memory numbers and
station names.
⁄7 TEN KEYPAD
They are useful for tuning a pre-set radio station and setting a station
name.
down buttons
down buttons

OPERATION OF REMOTE CONTROL UNIT

1. Remote control
The distance between the transmitter of the remote control unit and the
IR SENSOR of the SR7200 should be less than about 5 meters. If the
transmitter is pointed to a direction other than the IR SENSOR or if
there is an obstacle between them, remote control may not be possible.
Remote-controllable range
60°
Remote control unit (RC7200SR)
2. Loading batteries
The life of the batteries used with the remote control unit is about 4
months with normal use. Also be sure to replace batteries earlier when
you notice that they are getting weak.
(1) Remove the back cover.
(2) Insert the new batteries (AA type) with correct (+) and (–)
polarity.
(3) Close until it clicks.
8
SR7200