Direct Sending - Canon ImageRUNNER 2545i Sending And Facsimile Manual

Direct Sending

The following describes the flow of sending faxes using the Direct Sending mode.
IMPORTANT
• You can specify only one destination at a time for the Direct Sending mode.
• If an error occurs or you cancel transmission in the Direct Sending mode, you can
check how many pages have been sent to the destination by printing the
communication reports or using the System Monitor screen. (See "Printing
Communication Reports," on p. 8-9, or "Checking/Printing Communication Log," on
p. 6-9.)
2
1
Press
IMPORTANT
You can only send one page at a time when you place your original on the platen
glass. If you want to send a document of two or more pages, place your originals into
the feeder.
NOTE
• For instructions on how to place your originals, see Chapter 2, "Basic Operations," in
the Reference Guide.
• If <Enter your User Name and password and specify the login destination.> appears,
follow the instructions in "Logging in to Authorized Send," on p. 2-35.
• If any of the messages below appears, follow the instructions in Chapter 2, "Basic
Operations," in the Reference Guide:
- <Enter the Department ID and Password using the numeric keys.>
- <You must insert a control card.>
- <Enter the User ID and Password.>
2
2-28
Basic Sending Methods
(SEND) ➞ place your originals.
Press [New Address] ➞ [Fax].
NOTE
If Fax Send is set to 'Do not allow',
[Fax] is not displayed. (See Chapter 4,
"Customizing Settings," in the Remote
UI Guide.)