Throttle Friction Adjuster; Engine Shut-Off Cord (Lanyard) And Clip - Yamaha F225 Owner's Manual

2
22.5
3
1
1. Fully open
2. Fully closed
3. Free accelerator
The free throttle switch can only be used

when the control lever is in the neutral po-
sition.
During operation the digital electronic con-

trol-active indicator changes from continu-
ously lit to blinking. When the indicator
starts blinking, the throttle begins to open
after the control lever is moved at least
22.5.
After using the free throttle switch, return

the control lever to the neutral position.
The free throttle switch will return automat-
ically to its set position. The digital elec-
tronic control-active indicator will change
from blinking to continuously lit and the
digital electronic control will then engage
forward and reverse normally.
EMU35250

Throttle friction adjuster

A friction device provides adjustable resis-
tance to movement of the control lever, and
can be set according to operator preference.
To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn the
adjuster counterclockwise.
N
ZMU05883
EWM01770
WARNING
If the friction is too small, the control le-

ver could move freely and cause an ac-
cident.
Do not overtighten the friction adjuster.

If there is too much resistance, it could
be difficult to move the control lever,
which could result in an accident.
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25995
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
Components
ZMU05820
ZMU05819
30